 |
|||
|
|
|||
|
Page Title:
ENGINE COOLANT HEATER RESTRICTION THERMOSTAT MAINTENANCE - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-2
0419 00
ENGINE COOLANT HEATER RESTRICTION THERMOSTAT MAINTENANCE (Contd)
REMOVAL
NOTE
Prior to removal, tag lead wires for installation.
1.
Disconnect two leads (1) from restriction thermostat (3).
2.
Remove two nut-assembled lockwashers (2), restriction thermostat (3), and two spacers (4) from
two studs (5). Discard nut-assembled lockwashers (2).
INSPECTION
1.
Inspect restriction thermostat (3) for corrosion and bends. Replace if corroded or bent.
2.
Check restriction thermostat continuity at room temperature. If continuity exists, replace
restriction thermostat (3).
CAUTION
Do not place restriction thermostat in liquid for cooling. Placing
restriction thermostat in liquid will cause damage to
equipment.
3.
Cool restriction thermostat to 20 F (-6.7 C). Check restriction thermostat continuity. If continuity
does not exist, replace restriction thermostat.
INSTALLATION
1.
Install restriction thermostat (3) and two spacers (4) on two studs (5) with two new nut-assembled
lockwashers (2).
2.
Connect two leads (1) to restriction thermostat (3).
3.
Install engine coolant heater blower motor (WP 0418 00).
4.
Connect battery ground cable (WP 0126 00).
5.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
0419 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version