 |
|||
|
|
|||
|
Page Title:
BATTERY BOX AND HEATER PAD REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-2
0360 00
BATTERY BOX HEATER PAD REPLACEMENT (Contd)
HEATER PAD REMOVAL
WARNING
Accidental or intentional introduction of liquid contaminants
into the environment is a violation of state, federal, and military
regulations. Refer to Army POL (WP 0001 00) for information
concerning storage, use, and disposal of these liquids. Failure to
do so may result in damage to environment and health of
personnel.
NOTE
Prior to removal, close water manifold valve.
Use a drain pan to capture any draining coolant. Dispose of
fluids in accordance with local policy and ordinances. Ensure
all spills are cleaned up.
1.
Loosen two clamps (6) and remove exhaust inlet hose (9) and outlet hose (7) from heater pad (1).
2.
Remove heater pad (1) from battery box (3).
BATTERY BOX REMOVAL
1.
Remove two rubber grommets (2) from battery box (3) and battery cables.
2.
Remove four screws (4), lockwashers (5), spacers (8), and battery box (3) from cab floor (10).
Discard lockwashers (5).
BATTERY BOX INSTALLATION
1.
Install battery box (3) on cab floor (10), with four spacers (8), new lockwashers (5) and screws (4).
2.
Install two rubber grommets (2) on battery cables and battery box (3).
HEATER PAD INSTALLATION
1.
Install heater pad (1) in battery box (3).
2.
Install exhaust inlet hose (9) and outlet hose (7) on heater pad (1). Tighten clamps (6).
3.
Install batteries (WP 0127 00).
4.
Install companion seat (WP 0234 00).
5.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
1
3
2
4
5
6
10
7
~
6
8
9
END OF WORK PACKAGE
0360 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version