 |
|||
|
|
|||
|
Page Title:
THERMAL BARRIER INSULATION REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-2
0359 00
THERMAL BARRIER INSULATION REPLACEMENT (Contd)
REMOVAL
NOTE
All thermal barrier insulation is removed the same way. This
procedure covers replacement of left rear insulation panel only.
Other panels are shown for reference only.
1.
Remove panel (2) from cab interior (1). Discard panel (2) if irreparable damage occurs when
removing.
2.
Remove all remaining insulating material and adhesive from contact surface areas.
INSTALLATION
CAUTION
Once panel is coated with methylethylketone and put in place,
it cannot be moved. Be careful not to place panel in the wrong
position.
NOTE
Make all necessary cutouts and slits in panels before
installation.
Shiny side of panel must face outward.
1.
Place panel (2) on cab (1) to check for fit.
2.
Remove panel (2) and coat contact areas with methylethylketone.
3.
Install panel (2) on cab (1) and press firmly into place.
NOTE
If additional adhesive sealant is required, perform steps 4 and 5.
4.
Remove panel (2) and coat contact areas with adhesive sealant.
5.
Install panel (2) on cab (1) and press firmly into place.
6.
Install driver's seat (WP 0236 00).
7.
Install companion seat (WP 0234 00).
8.
Connect battery ground cable (WP 0126 00).
9.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
0359 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version