 |
|||
|
|
|||
|
Page Title:
AUTOMATIC BRAKE TEST AND ADJUSTMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-2
0344 00
AUTOMATIC BRAKE TEST AND ADJUSTMENT (Contd)
ADJUSTMENT
1.
Disengage hand throttle (3) on vehicle (1). Press clutch pedal (7) and place PTO lever (6) in reverse
position. Release clutch pedal (7) and unwind secondary vehicle (2) back to level ground and set
parking brake.
2.
Place PTO lever (6) in neutral position and disengage drum clutch lever (8).
3.
Adjust brake band by turning adjusting screw (10) in 1/2-turn clockwise increments to increase
braking action.
4.
Repeat testing and adjustment until correct adjustment is obtained.
NOTE
Perform steps 5 through 7 only when new winch is installed.
5.
Extend winch cable (9) for 5 minutes at engine idle (TM 9-2320-361-10).
6.
Allow brake band to cool for approximately 1-1/2 hours.
7.
Repeat brake band adjustment procedure.
8.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
1
2
WHEEL
CHOCK
0344 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version