Click here to make tpub.com your Home Page

Page Title: REAR COMPARTMENT DOOR MAINTENANCE - continued
Back | Up | Next

Click here for a printable version

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

TM 9-2320-361-24-2
0288 00
REAR COMPARTMENT DOOR MAINTENANCE (Contd)
WARNING
Diesel fuel is flammable. Do not perform fuel system procedures
near open flames. Injury or death to personnel may result.
DOOR REMOVAL
1.  Remove three locknuts (4), screws (16), and arm and stop (2) from door (3). Discard locknuts (4).
NOTE
Assistant will help with step 2.
2.
Remove ten locknuts (5), screws (6), and door (3) from tank body (1). Discard locknuts (5).
ARM AND STOP REMOVAL
1.  Remove two screws (17), and remove arm and stop (2) from tank body (1).
2.  Remove three locknuts (4), screws (16), and arm and stop (2) from door (3). Discard locknuts (4).
LOCK REMOVAL
1.  Remove four locknuts (11), screws (9), two straps (8), spacers (7), and lock pins (10) from door (3)
and lock (13). Discard locknuts (11)
2.  Remove four rivets (12) and lock (13) from door (3). Discard rivets (12).
CLEANING AND INSPECTION
1.  Refer to WP 0021 00 for general cleaning instructions.
2.  Inspect compartment door(s) (3) for dents, rust, or damage. Replace compartment door(s) (3) if
dented, extensively rusted, or damaged.
DOOR REPAIR
1.  Remove instruction plates (WP 0245 00) from area(s) to be painted/repaired.
2.  Remove paint or rust from area to be repaired (TM 43-0139).
3.  Repair compartment door(s) (3) (TC 9-237 and TC 9-510).
4.  Paint compartment door(s) (3) as required (TB 43-0209).
5.  Install instruction plates (WP 0245 00).
LOCK INSTALLATION
1.  Install lock (13) on door (3) with four new rivets (12).
2.  Install two lock pins (10) on lock (13) and door (3) with two screws (9), straps (8), spacers (7), and
four new locknuts (11).
ARM AND STOP INSTALLATION
1.  Install arm and stop (2) on door (3) with three screws (16), new locknuts (4).
2.  Install arm and stop (2) on tank body (1), with two screws (17).
DOOR INSTALLATION
1.  Install door (3) on tank body (1) with ten screws (6) and locknuts (5).
NOTE
Assistant will help with step 2.
2.
Install arm and stop (2) on door (3) with three screws (16) and locknuts (4).
3.
Connect battery ground cable (WP 0126 00).
4.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
0288 00-2

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business