 |
|||
|
|
|||
|
Page Title:
GATE VALVE REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-2
0283 00
GATE VALVE REPLACEMENT (Contd)
WARNING
Diesel fuel is flammable. Do not perform fuel system procedures
near open flames. Injury or death to personnel may result.
Accidental or intentional introduction of liquid contaminants
into the environment is a violation of state, federal, and
military regulations. Refer to Army POL (WP 0001 00) for
information concerning storage, use, and disposal of these
liquids. Failure to do so may result in damage to environment
and health of personnel.
NOTE
Use a drain pan to capture any draining fuel. Dispose of fluids
in accordance with local policy and ordinances. Ensure all spills
are cleaned up.
Both gate valves are removed the same way.
REMOVAL
1.
Remove four locknuts (9), screws (7), cover (6), and gasket (8) from gate valve (1). Discard
locknuts (9) and gasket (8). Remove gasket remains from mating surfaces.
2.
Remove four locknuts (2), screws (5), valve (1), and gasket (4) from manifold flange (3).
Discard locknuts (2) and gasket (4). Remove gasket remains from mating surfaces.
INSTALLATION
1.
Install new gasket (4) and valve (1) on manifold flange (3) with four screws (5) and new
locknuts (2).
2.
Install new gasket (8) and cover (6) on valve (1) with four screws (7) and new locknuts (9).
3.
Connect battery ground cable (WP 0126 00).
4.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
2
1
9
8
7
3
4
6
5
END OF WORK PACKAGE
0283 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version