 |
|||
|
|
|||
|
Page Title:
REAR CAB MOUNT AND BRACKET REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-2
0231 00
REAR CAB MOUNT REPLACEMENT (Contd)
WARNING
Do not place fingers between frame and crossmember while
replacing mount. Doing so may result in injury to personnel.
NOTE
Assistant will help with entire procedure.
REMOVAL
1.
Remove two rear cab mount locknuts (9), washers (8), screws (2), springs (4), and four washers (3)
from bracket (5) and frame (7). Discard locknuts (9).
WARNING
Support cab body while in raised position for mount
replacement. Failure to do so may result in injury to personnel.
CAUTION
Do not raise rear of cab too high when removing mounts.
Damage to cab may result.
2.
Raise cab (1) to provide clearance and remove two mounts (6) from frame (7).
3.
Remove four screw-assembled lockwashers (10) and bracket (5) from lower cab (1). Discard screw-
assembled lockwashers (10).
INSTALLATION
1.
Install bracket (5) on lower cab (1) with four new screw-assembled lockwashers (10).
2.
Install two new mounts (6) on frame (7).
3.
Lower cab (1) on mounts (6).
4.
Install two springs (4) and four washers (3) on two screws (2), and install screws (2) through
bracket (5), mounts (6), and frame (7).
5.
Install two washers (8) and two new locknuts (9) on screws (2). Tighten locknuts (9) to compress
springs (4) to height of 1.78 in. (4.52 cm).
6.
Connect battery ground cable (WP 0126 00).
7.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
0231 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version