 |
|||
|
|
|||
|
Page Title:
BRUSH GUARD, STONE SHIELD, AND HEADLIGHT GUARD REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-2
0203 00
BRUSH GUARD, STONE SHIELD, AND HEADLIGHT GUARD REPLACEMENT (Contd)
STONE SHIELD REMOVAL
NOTE
Radiator stone shield consists of an upper and lower stone
shield. Vehicles with a front winch do not use lower stone
shield.
Some vehicles may have washers between brush guard and
brush guard bracket.
1.
Remove four locknuts (19), screws (10), two washers (15), and lower stone shield (9) from brush
guard (4) and upper stone shield (7). Discard locknuts (19).
2.
Remove three locknuts (5), screws (8), brackets (6), and upper stone shield (7) from brush
guard (4). Discard locknuts (5).
HEADLIGHT GUARD REMOVAL
NOTE
This procedure can also be done with brush guard installed on
vehicle.
1.
Remove four locknuts (1), screws (20), and washers (21) from brush guard (4). Discard locknuts (1).
2.
If brush guard (4) was not removed from vehicle, remove two locknuts (22), washers (14),
screws (13), and headlight guard (2) from brush guard (4). Discard locknuts (22).
BRUSH GUARD REMOVAL
1.
Remove two locknuts (16) and screws (18) from brush guard (4) and frame rail brackets (17).
Discard locknuts (16).
2.
Remove four locknuts (1) and (22), four washers (21) and (14), screws (20) and (13), and brush
guard (4) from angle brackets (3). Discard locknuts (1) and (22).
NOTE
Vehicles without front winch have an additional brush guard
bracket.
If vehicle is equipped with lower stone shield, proceed to
step 4.
3.
Remove two locknuts (19), screws (10), washers (15), and upper brush guard bracket (12) from
brush guard (4). Discard locknuts (19).
4.
Remove two locknuts (19), screws (10), washers (15), and lower brush guard bracket (11) from
brush guard (4). Discard locknuts (19).
BRUSH GUARD INSTALLATION
1.
Install upper brush guard bracket (12) on brush guard (4) with two screws (10), washers (15), and
new locknuts (19).
2.
Install lower brush guard bracket (11) on brush guard (4) with two screws (10), washers (15), and
new locknuts (19).
3.
Position brush guard (4) on two frame rail brackets (17) and install with two screws (18) and new
locknuts (16). Do not tighten locknuts (16).
4.
Position brush guard (4) on angle brackets (3). Install four screws (13) and (20), washers (2)
and (14), and locknuts (1) and (22) on brush guard (4), headlight guard (2), and two angle
brackets (3). Tighten locknuts (16).
0203 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version