 |
|||
|
|
|||
|
Page Title:
AIR COMPRESSOR MAINTENANCE - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0181 00
AIR COMPRESSOR MAINTENANCE (Contd)
REMOVAL
1.
Loosen two screws (5) on intake air cleaner (2).
2.
Remove two screws (4), lockwashers (3), intake air cleaner (2), and gasket (1) from air
compressor (6). Discard lockwashers (3) and gasket (1).
DISASSEMBLY
1.
Remove two screws (5) from intake air cleaner (2).
2.
Remove cap (10), spring (9), plate (8), and filter (7) from body of intake air cleaner (2).
CLEANING
WARNING
Skysol 100 solvent is combustible; DO NOT use or store near
heat, sparks, flame, or other ignition sources. Use mechanical
ventilation whenever product is used in a confined space,
heated above ambient temperatures, or agitated. Keep
container sealed when not in use.
Contact with Skysol 100 may cause skin irritation. Use
chemical-resistant gloves. In case of skin contact, remove any
contaminated clothing and wash skin thoroughly with soap
and water. Wash contaminated clothing before reuse. Eye
contact may cause irritation, tearing, or blurring of vision.
Use face shield or goggles when eye contact may occur. In
case of eye contact, flush eyes with large amounts of water for
at least 15 minutes or until irritation subsides. Inhalation
may cause irritation to upper respiratory passages. DO NOT
have food or drink in the vicinity. Failure to comply may
result in injury to personnel.
Compressed air used for cleaning must not exceed 30 psi
(207 kPa). Wear goggles/face shield and gloves when cleaning
with compressed air. Failure to do so may result in injury to
personnel.
1.
Wash filter (7) in Skysol 100 solvent.
2.
Using compressed air source, clean and dry filter (7).
ASSEMBLY
1.
Install filter (7), plate (8), and spring (9) in body of intake air cleaner (2).
2.
Install cap (10) on intake air cleaner (2) with two screws (5), Tighten screws (5) finger-tight.
INSTALLATION
1.
Install new gasket (1) and intake air cleaner (2) on air compressor (6) with two new
lockwashers (3) and screws (4).
2.
Tighten two screws (5).
3.
Start engine (TM 9-2320-361-10), buildup air pressure, and check air compressor operation.
4.
Raise and lock side panel and lower hood (TM 9-2320-361-10).
5.
Connect battery ground cable (WP 0126 00).
6.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
0181 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version