 |
|||
|
|
|||
|
Page Title:
SERVICE BRAKESHOES MAINTENANCE - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0167 00
SERVICE BRAKESHOES MAINTENANCE (Contd)
WARNING
Do not use a dry brush or compressed air to clean brakeshoes.
There may be asbestos dust on brakeshoes which can be
dangerous to your health if you breathe it. (Brakeshoes must be
wet, and soft bristle brush must be used.)
NOTE
The replacement procedure for front and rear service
brakeshoes are done the same way. This procedure covers the
front service brakes.
If any brakeshoes are to be replaced, replace all brakeshoes
on both ends of an axle.
REMOVAL
1.
Remove brakeshoe return spring (24) from brakeshoes (2) and (19).
2.
Remove two nuts (7), washers (6), anti-rattle springs (4), washers (3), and upper (long) guide
pins (1) from backing plate (5). Discard nuts (7), washers (6), and guide pins (1).
3.
Remove two nuts (10), washers (11), lower (short) guide pins (20), and retainer washers (18) from
backing plate (5). Discard nuts (10), washers (11), and guide pins (20).
4.
Remove two slotted retainers (22) and washers (23) from two anchor pins (21). Discard slotted
retainers (22).
5.
Remove two brakeshoes (2) and (19), retainer washers (17), and felt washers (14) from anchor
pins (21), backing plate (5), and wheel cylinder pushrods (8).
6.
Remove two cams (16), springs (15), and adjusting pins (9) from backing plate (5).
7.
Remove two nuts (12), washers (13), and anchor pins (21) from backing plate (5).
0167 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version