 |
|||
|
|
|||
|
Page Title:
REAR SPRING SEAT REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0159 00
REAR SPRING SEAT REPLACEMENT (Contd)
REMOVAL
WARNING
Ensure vehicle is firmly supported while spring seat is
removed. Failure to comply may cause injury to personnel.
NOTE
Right and left spring seats are replaced the same way. This
procedure covers the left side.
1.
Support vehicle with two jack stands at tandem axle bracket (4).
2.
Raise axles (6) so that spring (1) is not resting against brackets (5).
3.
Remove two screws (7) and lockwashers (8) from spring seat (21). Discard lockwashers (8).
4.
Remove four nuts (10), lockwashers (9), two U-bolts (2), and saddle (3) from spring (1). Discard
lockwashers (9).
5.
Using hydraulic jack, raise and support rear-rear axle (6) until spring (1) is lifted off spring
seat (21). Readjust jack stands under axle (6).
6.
Remove six screws (17), lockwashers (18), pack cover (19), and gasket (20) from spring seat (21).
Discard lockwashers (18) and gasket (20).
7.
Straighten washer (15) tabs.
8.
Remove nut (16), washer (15), nut (14), outer bushing (13), and spring seat (21) from tandem axle
bracket (4) end. Discard washer (15).
9.
Remove two bushing cups (12) and (26) from spring seat (21). Discard bushing cups (12) and (26).
10.
Remove plug (11) from spring seat (21).
NOTE
Use care when installing retainer and washer in the following
step.
11.
Remove inner bushing (27), seal (25), retainer (24), felt seal (23), washer (22), and woodruff
key (28) from tandem axle bracket (4) end. Do not bend washer (22) or retainer (24). Discard
seal (25), felt seal (23), and woodruff key (28).
0159 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version