 |
|||
|
|
|||
|
Page Title:
STEERING KNUCKLE AND STEERING ARM MAINTENANCE - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0150 00
STEERING KNUCKLE AND STEERING ARM MAINTENANCE (Contd)
CLEANING AND INSPECTION
1.
For general cleaning instructions, refer to WP 0021 00.
2.
Measure outside diameter of ball stud (21). Replace ball stud (21) if outside diameter is less than
1.24 in. (3.15 cm).
3.
Visually inspect ball stud (21) for nicks, scratches, pits, scores, or scratches. Replace ball stud (21)
if damaged.
4.
Measure outside diameter of steering knuckle pins (18). Replace front axle if outside diameter of
steering knuckle pin is less than 1.123 in. (2.852 cm).
5.
Inspect steering knuckle pins (18) for nicks, scratches, pitting, scores, and cracks. Replace front
axle if pins (18) are nicked, scratched, pitted, scored, or cracked.
6.
Inspect sleeves (17) and (20) for nicks, scratches, scores, cracks, and signs of wear. Replace
sleeve (17) or (20) and bearing (16) or (9) if nicked, scratched, scored, cracked, or worn.
7.
Measure inside diameter of bearings (9) and (16). Replace bearing (9) or (16) if inside diameter is
greater than 1.126 in. (2.860 cm).
8.
Inspect bearings (9) and (16) for nicks, scratches, pitting, scores, or cracks. Replace if nicked,
scratched, pitted, scored, or cracked.
9.
Inspect four studs (19) and twelve studs (11) for bends or stripped threads. Replace stud(s) (19)
or (11) if bent or threads are stripped.
10.
Inspect turn angle screw (7) and nut (6) for damage. Replace turn angle screw (7) and nut (6) if
damaged.
STEERING KNUCKLE INSTALLATION
1.
Install left and right steering knuckles (10) on pins (18) with studs (19) facing up.
2.
Install sleeve (17), plate (15), and bearing (16) on left and right steering knuckles (10) with two
new lockwashers (12) and screws (13). Tighten screws (13) 116149 lb-ft (157202 Nm).
3.
Install sleeve (20), bearing (9), and spacer (8) on left and right steering knuckles (10).
NOTE
Perform steps 4 and 5 for right steering knuckle. Perform step 6
for left steering knuckle.
4.
Install plate (24) with four new lockwashers (25) and screws (22) on steering knuckle (10). Tighten
screws (22) 116149 lb-ft (157202 Nm).
5.
Install lubrication fitting (23) on plate (24) and lubrication fitting (14) on plate (15).
6.
Install lubrication fitting (4) on steering arm (5).
STEERING ARM INSTALLATION
1.
Install four new bushings (1) on steering arm (5).
2.
Install steering arm (5) on four studs (19) with four new lockwashers (3) and nuts (2). Tighten
nuts (2) 130167 lb-ft (176226 Nm).
3.
Install lubrication fitting (4) on steering arm (5).
0150 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version