 |
|||
|
|
|||
|
Page Title:
FRONT AND REAR DIFFERENTIAL OIL SEAL REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0149 00
FRONT AND REAR DIFFERENTIAL OIL SEAL REPLACEMENT (Contd)
REMOVAL
1.
Remove cotter pin (12), nut (1), and washer (2) from shaft (8). Discard cotter pin (12).
2.
Remove flange (3) from shaft (8).
NOTE
Perform step 3 if replacing dirt deflectors.
3.
Remove dirt deflector (4) from flange (3).
4.
Remove six screws (11) and washers (10) from retainer (6).
NOTE
Count and record number of shims for installation.
5.
Remove retainer (6) and shims (7) from carrier (9).
6.
Remove oil seal (5) from retainer (6). Discard oil seal (5).
INSTALLATION
1.
Install new oil seal (5) in retainer (6).
2.
Install shims (7) and retainer (6) on carrier (9) with six washers (10) and screws (11). Tighten
screws (11) 6585 lb-ft (88115 Nm).
NOTE
Perform step 3 if replacing dirt deflectors.
3.
Install dirt deflector (4) on flange (3) and install flange (3) on shaft (8).
4.
Install washer (2) and nut (1) on shaft (8). Tighten nut (1) 300600 lb-ft (407814 Nm).
5.
Install new cotter pin (12) on nut (1) and shaft (8).
6.
Install propeller shaft (WP 0139 00).
7.
Connect battery ground cable (WP 0126 00).
8.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
0149 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version