 |
|||
|
|
|||
|
Page Title:
INTERMEDIATE PROPELLER SHAFT MAINTENANCE (M36A2) - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0140 00
INTERMEDIATE PROPELLER SHAFT MAINTENANCE (M36A2) (Contd)
CLEANING AND INSPECTION
WARNING
Skysol 100 solvent is combustible; DO NOT use or store near
heat, sparks, flame, or other ignition sources. Use mechanical
ventilation whenever product is used in a confined space,
heated above ambient temperatures, or agitated. Keep
container sealed when not in use.
Contact with Skysol 100 may cause skin irritation. Use
chemical-resistant gloves. In case of skin contact, remove any
contaminated clothing and wash skin thoroughly with soap and
water. Wash contaminated clothing before reuse. Eye contact
may cause irritation, tearing, or blurring of vision. Use face
shield or goggles when eye contact may occur. In case of eye
contact, flush eyes with large amounts of water for at least 15
minutes or until irritation subsides. Inhalation may cause
irritation to upper respiratory passages. DO NOT have food or
drink in the vicinity. Failure to comply may result in injury to
personnel.
1.
Clean all parts with Skysol 100 and dry with clean rag.
2.
Clean and inspect bearing (19) in accordance with TM 9-214.
3.
Inspect universal joint (24) for roughness and free play. Replace universal joint (24) if loose or
rough (WP 0141 00).
4.
Inspect propeller shaft (23) for:
a. Breaks, cracks, or bends. Replace if cracked, bent, or broken.
b. Crossed or stripped threads. Replace if threads are crossed or stripped.
c. Nicked or burred splines (28). Replace if splines are cracked or chipped.
d. Bearing shoulder nicked, burred, or scored. Replace if bearing shoulder is nicked, burred,
scored, or bearing (19) is frozen.
5.
Inspect shield (20) for cracks, breaks, or bends. Replace shield (20) if cracked, broken, or bent.
6.
Inspect flange (11) for cracks, breaks, and bent deflector (12). Replace flange (11) if damaged.
7.
Inspect rubber insulators (14) for tears or breaks. Replace rubber insulators (14) if torn or broken.
8.
Inspect bearing housing (17) for cracks and breaks. Replace bearing housing (17) if cracked or
broken.
9.
Inspect frame support (4) for breaks and cracks. Replace frame support (4) if broken or cracked.
ASSEMBLY
1.
Apply a light film of GAA grease to bearing (19) outer race and inner bore of bearing housing (17).
Install bearing (19) in bearing housing (17). Ensure bearing (19) is seated square in bearing
housing (17).
2.
Install two new seals (13) in shaft side of bearing housing (17).
3.
Slide shield (20) on shaft (23) as far as it will go.
4.
Install shield (20) with screw (22) and new lockwasher (21) on shaft (23).
5.
Install four rubber insulators (14) in bearing housing (17).
NOTE
Perform step 6 if lubrication fitting was removed.
6.
Install lubrication fitting (18) in bearing housing (17).
0140 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version