 |
|||
|
|
|||
|
Page Title:
TRANSFER CASE CONTROLS AND LINKAGE MAINTENANCE (W/PTO) - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0133 00
TRANSFER CASE CONTROLS AND LINKAGE MAINTENANCE (W/PTO) (Contd)
REMOVAL (Contd)
NOTE
Assistant will help with step 13.
13.
Remove four locknuts (10), screws (3), and two mounting brackets (1) with PTO shift control
handle (4) from cab floor (9). Discard locknuts (10).
14.
Remove seal (13) from cab floor (9).
15.
Remove locknut (14), screw (16), lever (15), and woodruff key (12) from PTO shift control
shaft (11). Discard locknut (14) and woodruff key (12).
16.
Remove two mounting brackets (1) from PTO shift control shaft (11) and remove two lubrication
fittings (2) from two mounting brackets (1).
17.
Remove locknut (8), screw (7), spring (6), and control lock (5) from PTO shift control handle (4).
Discard locknut (8).
CLEANING AND INSPECTION
WARNING
Skysol 100 solvent is combustible; DO NOT use or store near
heat, sparks, flame, or other ignition sources. Use mechanical
ventilation whenever product is used in a confined space,
heated above ambient temperatures, or agitated. Keep
container sealed when not in use.
Contact with Skysol 100 may cause skin irritation. Use
chemical-resistant gloves. In case of skin contact, remove any
contaminated clothing and wash skin thoroughly with soap and
water. Wash contaminated clothing before reuse. Eye contact
may cause irritation, tearing, or blurring of vision. Use face
shield or goggles when eye contact may occur. In case of eye
contact, flush eyes with large amounts of water for at least 15
minutes or until irritation subsides. Inhalation may cause
irritation to upper respiratory passages. DO NOT have food or
drink in the vicinity. Failure to comply may result in injury to
personnel.
1.
Clean all parts with Skysol 100 and wipe dry with clean rag.
2.
Inspect all parts for breaks, bends, and cracks. Replace parts if broken, bent, or cracked.
3.
Ball and socket joints are not repairable and must be discarded if there is damage or free play.
Ball studs must swivel freely.
4.
Inspect threaded parts for stripped or crossed threads. Discard threaded parts if threads are
stripped or cross-threaded.
5.
Inspect spring (6) for breaks, distortion, or collapsed coils. Discard spring (6) if broken, distorted,
or coils are collapsed.
0133 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version