 |
|||
|
|
|||
|
Page Title:
TRANSMISSION REMOVAL - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0131 00
TRANSMISSION REMOVAL (Contd)
REMOVAL
1.
Remove clutch return spring (2) from clutch shaft lever (1) and frame (3).
2.
Remove locknut (4), screw (5), and rod (6) from shaft lever (1). Discard locknut (4).
NOTE
Do not remove spring-loaded pin from clevis. Bearing will fall
free from clevis if pin is removed.
Step 3 applies to vehicles with transmission power takeoff
installed.
3.
Pull pin (16) to one side of clevis (18) on power takeoff shift lever (17) and remove PTO shift
lever (17) from PTO arm (19).
4.
Pull pin (7) to one side of clevis (8) on rod (6) and remove rod (6) from lever (9).
NOTE
Mark position of lever and shaft for installation.
5.
Remove locknut (22), screw (23), and lever (9) from shaft (21). Discard locknut (22).
NOTE
Screw-assembled lockwashers must be reinstalled in
transmission if transmission requires replacement.
6.
Remove four screw-assembled lockwashers (14) from transmission (15). Discard screw-assembled
lockwashers (14).
7.
Install utility chains on transmission (15) with four washers (13) and screws (12).
8.
Attach utility chains to sling. Attach sling to lifting device.
WARNING
Use prybar to free transmission during lifting operations.
Failure to do so may result in injury to personnel or damage
to equipment.
All personnel must stand clear during lifting operations. A
swinging or shifting load may cause injury to personnel.
Lifting device must have a weight capacity greater than the
weight of the transmission to prevent damage to equipment
and injury to personnel.
NOTE
If a new transmission is not being installed, the adapter plate
may be removed and installed with the transmission.
9.
Remove twelve screw-assembled lockwashers (20), ground strap (24), and lockwasher (25) from
flange of transmission (15). Discard screw-assembled lockwashers (20) and lockwasher (25).
10.
Remove transmission (15) and gasket (11) from flywheel housing (10) and lower transmission (15).
Discard gasket (11).
11.
Remove lifting device from sling. Remove sling from utility chains.
12.
Remove four screws (12), washers (13), and utility chains from transmission (15).
0131 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version