 |
|||
|
|
|||
|
Page Title:
OIL PRESSURE GAUGE, BATTERY AND ALTERNATOR GAUGE, FUEL GAUGE, AND ENGINE TEMPERATURE GAUGE REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0095 00
OIL PRESSURE GAUGE, BATTERY AND ALTERNATOR GAUGE, FUEL GAUGE, AND ENGINE
TEMPERATURE GAUGE REPLACEMENT (Contd)
CAUTION
The 60 psi and 120 psi gauges and sending units are not
interchangeable. Installation of improper gauge may result in
damage to equipment.
NOTE
Engine temperature, oil pressure, battery and alternator, and
fuel gauges are removed and installed the same. This procedure
covers the engine temperature gauge.
REMOVAL
1.
Turn four lockstuds (5) turn to left and pull instrument cluster (7) away from instrument
panel (8).
NOTE
Prior to removal, tag lead wires for installation.
2.
Disconnect lead wires (1) and (9) from engine temperature gauge (6).
3.
Remove two nuts (2), lockwashers (3), and bracket (4) from temperature gauge (6). Discard
lockwashers (3).
4.
Remove engine temperature gauge (6) from instrument cluster (7).
INSTALLATION
1.
Position engine temperature gauge (6) through front of instrument cluster (7).
2.
Install bracket (4) on temperature gauge (6) with two new lockwashers (3) and nuts (2).
3.
Connect lead wires (1) and (9) to engine temperature gauge (6).
4.
Position instrument cluster (7) on instrument panel (8) and install by turning four lockstuds (5)
1/4 turn to right.
5.
Connect battery ground cable (WP 0126 00).
6.
Start engine (TM 9-2320-361-10) and check gauges for proper operation.
7.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
0095 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version