 |
|||
|
|
|||
|
Page Title:
ALTERNATOR BELTS MAINTENANCE - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0084 00
ALTERNATOR BELTS MAINTENANCE (Contd)
REMOVAL
1.
Loosen screw (9) and nut (2) on alternator adjusting arm (1).
2.
Remove two cotter pins (6) and loosen front and rear locknuts (7). Discard cotter pins (6).
3.
Rotate alternator (12) toward engine (11) and remove two alternator belts (4) from alternator
pulley (8), water pump pulley (3), and vibration damper (5).
INSPECTION
Inspect two alternator belts (4) for cracks, fraying, and splits. Replace if cracked, frayed, or split.
INSTALLATION AND ADJUSTMENT
NOTE
Alternator belts are a matched set.
1.
Install two alternator belts (4) on vibration damper (5), water pump pulley (3), and alternator
pulley (8).
2.
Position suitable prybar (10) between engine (11) and alternator (12). Pull prybar (10) down until
belts (4) appear tight.
3.
Place straightedge (13) across alternator pulley (8) and water pump pulley (3) and check for
0.75 in. (19.05 mm) deflection on alternator belts (4).
4.
Tighten screw (9) at adjusting arm (1) 1520 lb-ft (2027 Nm).
5.
Tighten nut (2) at adjusting arm (1) 2531 lb-ft (3442 Nm).
6.
Tighten two locknuts (7) and install two new cotter pins (6). Tighten locknuts (7) 3342 lb-ft
(4557 Nm).
7.
Connect battery ground cable (WP 0126 00).
8.
Start engine (TM 9-2320-361-10) and check if battery-generator indicator is in green area.
9.
Lower and secure hood (TM 9-2320-361-10).
10.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
3
2
4
1
9
8
7
5
6
0084 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version