 |
|||
|
|
|||
|
Page Title:
OIL COOLER TUBE AND HOSES REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0083 00
OIL COOLER TUBE AND HOSE REPLACEMENT (Contd)
WARNING
Accidental or intentional introduction of liquid contaminants
into the environment is a violation of state, federal, and
military regulations. Refer to Army POL (WP 0001 00) for
information concerning storage, use, and disposal of these
liquids. Failure to do so may result in damage to environment
and health of personnel.
NOTE
Use a drain pan to capture any draining oil. Dispose of fluids
in accordance with local policy and ordinances. Ensure all spills
are cleaned up.
REMOVAL
1.
Loosen four clamps (2) on two hoses (3).
2.
Remove oil cooler tube (5), two hoses (3), and four clamps (2) from water pump (1) and engine oil
cooler (4).
INSTALLATION
1.
Install oil cooler tube (5) and two hoses (3) on water pump (1) and engine oil cooler (4) with four
clamps (2).
2.
Tighten four clamps (2) on two hoses (3).
3.
Fill cooling system (WP 0076 00).
4.
Connect battery ground cable (WP 0126 00).
5.
Lower and secure hood (TM 9-2320-361-10).
6.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
2
2
3
4
3
1
5
END OF WORK PACKAGE
0083 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version