 |
|||
|
|
|||
|
Page Title:
ENGINE STOP CONTROL CABLE MAINTENANCE - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0071 00
ENGINE STOP CONTROL CABLE MAINTENANCE (Contd)
REMOVAL
1.
Remove tiedown strap (8) and engine stop control cable (1) from around steering column (9).
2.
Remove nut (19), two lockwashers (12), and screw (13) from clamp (16). Discard lockwashers (12).
3.
Straighten end of control cable wire (11) and loosen screw (10) on swivel (21).
4.
Remove control cable wire (11) and control cable (1) from swivel (21) and clamp (16).
5.
Remove cotter pin (18), swivel (21), and screw (10) from fuel shutoff valve (20). Discard cotter
pin (18).
6.
Remove screw (14), lockwasher (15), and clamp (16) from fuel injection pump (17). Discard
lockwasher (15).
7.
Loosen nut (6) behind instrument panel (5) and slide nut (6) and lockwasher (3) back on control
cable (1).
8.
Remove engine stop control (4) from instrument panel (5) and remove nut (6) and lockwasher (3)
from cable (1) as end of cable (1) comes through grommet (7) in firewall (2). Discard lockwasher (3).
9.
Remove grommet (7) from firewall (2).
INSTALLATION
1.
Install grommet (7) on firewall (2).
2.
Route end of engine stop control (4) through instrument panel (5).
3.
Position new lockwasher (3) and nut (6) on end of control cable (1) and insert control cable (1)
through grommet (7) and firewall (2).
4.
Install engine stop control (4) on instrument panel (5) with lockwasher (3) and nut (6).
5.
Install clamp (16) on fuel injection pump (17) with new lockwasher (15) and screw (14).
6.
Install swivel (21) on fuel shutoff valve (20) with new cotter pin (18) and install screw (10) on
swivel (21). Do not tighten.
7.
Slide control cable (1) through clamp (16) and control cable wire (11) through swivel (21).
8.
Install two new lockwashers (12), screw (13), and nut (19) on clamp (16). Do not tighten nut (19).
9.
Connect battery ground cable (WP 0126 00).
ADJUSTMENT
1.
Push ENGINE STOP control (4) all the way in.
2.
Pull fuel shutoff valve (20) out (toward firewall).
3.
Position control cable (1) in clamp (16) with end at least 1/2 in. (13 mm) away from fuel shutoff
valve (20).
4.
Tighten nut (19) on screw (13).
5.
Push fuel shutoff valve (20) all the way in and tighten screw (10) on control cable wire (11). Bend
end of control cable wire (11) up.
6.
Install tiedown strap (8) around steering column (9) and control cable (1).
7.
Start and stop engine (TM 9-2320-361-10).
8.
Lower and secure hood (TM 9-2320-361-10).
9.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
0071 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version