 |
|||
|
|
|||
|
Page Title:
FUEL PUMP (IN-TANK) FUSE REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0059 00
FUEL PUMP (IN-TANK) FUSE REPLACEMENT (Contd)
WARNING
Diesel fuel is flammable. Do not perform fuel system
procedures near open flames. Injury or death to personnel may
result.
REMOVAL
1.
Remove lead seal (4) from stud (7) by cutting wire (3). Discard wire (3) and lead seal (4).
2.
Remove three nuts (2), lockwashers (5), and terminal cover (1) from fuel pump (8). Discard
lockwashers (5).
3.
Remove screw (10) and disconnect wire (11) from terminal cover (1).
4.
Remove gasket (9) from fuel pump (8). Discard gasket (9).
5.
Remove fuse (6) from terminal cover (1).
INSTALLATION
1.
Install 4-amp fuse (6) on terminal cover (1).
2.
Install gasket (9) on fuel pump (8) and connect wire (11) to terminal cover (1) with screw (10).
3.
Install terminal cover (1) on fuel pump (8) with three new lockwashers (5) and nuts (2).
4.
Install new lead seal wire (3) through one stud (7). Thread end of seal wire (3) back through lead
seal and fasten using an adequate crimping tool.
5.
Connect battery ground cable (WP 0126 00).
6.
Start engine (TM 9-2320-361-10) and check fuel pump connections for leaks.
7.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
3
2
1
4
11
5
10
6
9
7
8
END OF WORK PACKAGE
0059 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version