 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0046 00
ENGINE REPLACEMENT (Contd)
INSTALLATION (Contd)
WARNING
Keep hands clear of supported engine during placement of engine
mounts. Failure to do so may result in injury to personnel.
13.
Position two mounting pads (20) and (31) on frame (23) and crossmember (30).
14.
Lower engine (1) until it rests on frame (23) and crossmember (30). Ensure mounting holes are aligned.
15.
Install two washers (32), screws (33), lower mounting pads (29), washers (28), and new locknuts (27)
on support plate (10) and crossmember (30). Tighten locknuts (27) 6570 lb-ft (8895 Nm).
16.
Install two washers (18), screws (17), lower mounting pads (24), washers (25), and new locknuts (26)
on frame (23). Finger-tighten locknuts (26).
17.
Tighten locknuts (26) 6570 lb-ft (8895 Nm).
18.
Remove lifting device and sling from chain and front lifting bracket (11).
19.
Remove nut (15), screw (12), washers (14) and (13), and chain from rear mounting bracket (16).
NOTE
Perform step 20 if vehicle is equipped with transmission PTO.
20.
Position clevis (22) on PTO arm (19) and push pin (21) in clevis (22) until head of pin (21) seats
against clevis (22).
SLING
LIFTING DEVICE
13
14 15
12
11
16
1
17
18
33
19
32
20
22
10
21
31
23
24
30
25
29
26
28
27
0046 00-15
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version