 |
|||
|
|
|||
|
Page Title:
ENGINE OIL FILTER AND BODY MAINTENANCE - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0044 00
ENGINE OIL FILTER AND BODY MAINTENANCE (Contd)
CLEANING AND INSPECTION
WARNING
Skysol 100 mixture is combustible; DO NOT use or store near
heat, sparks, flame, or other ignition sources. Use mechanical
ventilation whenever product is used in a confined space,
heated above ambient temperatures, or agitated. Keep
container sealed when not in use.
Contact with Skysol 100 may cause skin irritation. Use
chemical-resistant gloves. In case of skin contact, remove any
contaminated clothing and wash skin thoroughly with soap
and water. Wash contaminated clothing before reuse. Eye
contact may cause irritation, tearing, or blurring of vision.
Use face shield or goggles when eye contact may occur. In
case of eye contact, flush eyes with large amounts of water for
at least 15 minutes or until irritation subsides. Inhalation
may cause irritation to upper respiratory passages. DO NOT
have food or drink in the vicinity. Failure to comply may
result in injury to personnel.
Compressed air source must not exceed 30 psi (207 Kpa).
When cleaning with compressed air, eyeshields must be worn.
Failure to wear eyeshields may result in injury to personnel.
1.
Clean center post (1) and body (2) with Skysol 100 and dry with compressed air.
2.
Inspect body (2) for cracks. Replace body (2) if cracked.
3.
Inspect center post (1) for stripped threads. Replace center post (1) if threads are stripped.
4.
Inspect filter housing (3) for cracks, nicks, and stripped threads. Notify your supervisor if filter
housing (3) is cracked, nicked, or threads are stripped.
5.
Inspect cup (8) for cracks and grooves. Replace cup (8) if cracked or grooved.
6.
Inspect spring (7) for cracks and breaks. Replace spring (7) if cracked or broken.
BODY ASSEMBLY
NOTE
Both engine oil filter bodies are assembled the same.
1.
Place new gasket (6) on center post (1) and install center post (1) on body (2).
2.
Install spring (7), cup (8), new filter element (9), and new cotter pin (5) on center post (1) and
body (2).
OIL FILTER INSTALLATION
NOTE
Both engine oil filter bodies are installed the same.
1.
Coat new gasket (4) with light film of engine oil.
2.
Install new gasket (4) and body (2) on filter housing (3). Tighten center post (1) to 60 lb-ft
(81 Nm).
3.
Fill engine crankcase to proper fluid level (TM 9-2320-361-10).
4.
Connect battery ground cable (WP 0126 00).
5.
Start engine and check for leaks (TM 9-2320-361-10).
6.
Lower and secure hood (TM 9-2320-361-10).
7.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
0044 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version