 |
|||
|
|
|||
|
Page Title:
ENGINE OIL FILTER AND BODY MAINTENANCE - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0044 00
ENGINE OIL FILTER AND BODY MAINTENANCE (Contd)
WARNING
Accidental or intentional introduction of liquid contaminants
into the environment is a violation of state, federal, and
military regulations. Refer to Army POL (WP 0001 00) for
information concerning storage, use, and disposal of these
liquids. Failure to do so may result in damage to environment
and health of personnel.
Do not drain oil when engine is hot. Hot oil may cause injury
to personnel.
NOTE
Use a drain pan to capture any draining oil. Dispose of fluids in
accordance with local policy and ordinances. Ensure all spills
are cleaned up.
DRAINING OIL
1.
Remove two drainplugs (3) and seals (2) from engine oil pan (1), and allow oil to completely drain.
Discard seals (2).
2.
Install two new seals (2) and drainplugs (3) to engine oil pan (1).
OIL FILTER REMOVAL
1.
Remove pipe plug (6) from filter housing (7) and allow oil to drain.
NOTE
Both engine oil filter bodies are removed the same way.
2.
Loosen center post (4) and remove body (5) and gasket (8) from filter housing (7). Discard
gasket (8).
3.
Install pipe plug (6) on filter housing (7).
BODY DISASSEMBLY
NOTE
Both engine oil filter bodies are disassembled the same.
1.
Remove cotter pin (10), filter element (9), cup (13), and spring (12) from center post (4) and
body (5). Discard cotter pin (10) and filter element (9).
2.
Remove center post (4) and gasket (11) from body (5). Discard gasket (11).
0044 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version