 |
|||
|
|
|||
|
Page Title:
CRANKCASE BREATHER TUBE MAINTENANCE - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0043 00
CRANKCASE BREATHER TUBE MAINTENANCE (Contd)
REMOVAL
1.
Disconnect tube (5) and remove adapter (6) from crankcase breather tube (4).
2.
Remove screw (8) and lockwasher (7) from crankcase breather tube (4) and turbocharger (9).
Discard lockwasher (7).
3.
Loosen two clamps (2) and remove crankcase breather tube (4), hose (3), and two clamps (2) from
breather tube adapter (1) and turbocharger (9).
CLEANING AND INSPECTION
WARNING
Skysol 100 mixture is combustible; DO NOT use or store near
heat, sparks, flame, or other ignition sources. Use mechanical
ventilation whenever product is used in a confined space,
heated above ambient temperatures, or agitated. Keep
container sealed when not in use.
Contact with Skysol 100 may cause skin irritation. Use
chemical-resistant gloves. In case of skin contact, remove any
contaminated clothing and wash skin thoroughly with soap
and water. Wash contaminated clothing before reuse. Eye
contact may cause irritation, tearing, or blurring of vision.
Use face shield or goggles when eye contact may occur. In
case of eye contact, flush eyes with large amounts of water for
at least 15 minutes or until irritation subsides. Inhalation
may cause irritation to upper respiratory passages. DO NOT
have food or drink in the vicinity. Failure to comply may
result in injury to personnel.
Compressed air source must not exceed 30 psi (207 Kpa).
Wear eyeshields when cleaning with compressed air. Failure
to wear eyeshields may result in injury to personnel.
Clean crankcase breather tube (4) and hose (3) with Skysol 100 and dry with compressed air.
Remove obstructions. Replace if bent.
INSTALLATION
1.
Install hose (3) and crankcase breather tube (4) on breather tube adapter (1) with two clamps (2).
2.
Install crankcase breather tube (4) on turbocharger (9) with new lockwasher (7) and screw (8).
3.
Install adapter (6) on crankcase breather tube (4), and connect tube (5) to adapter (6).
4.
Connect battery ground cable (WP 0126 00).
5.
Lower and secure hood (TM 9-2320-361-10).
6.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
0043 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version