 |
|||
|
|
|||
|
Page Title:
INTAKE AND EXHAUST MANIFOLDS MAINTENANCE - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0041 00
INTAKE AND EXHAUST MANIFOLDS MAINTENANCE (Contd)
EXHAUST MANIFOLD ASSEMBLY
1.
Install six new flange seal rings (14) on manifold sections (13) and (15).
2.
Install manifold sections (13) and (15) in manifold section (17).
3.
Install two plugs (16) in exhaust manifold sections (13) and (15).
INTAKE AND EXHAUST MANIFOLDS INSTALLATION
1.
Position two new gaskets (4) on thirty studs (3).
NOTE
Assistant will help with steps 2 and 3.
2.
Install exhaust manifold (10) on twelve studs (3) and cylinder head (1) with twelve washers (11)
and new locknuts (12). Do not tighten locknuts (12).
3.
Hold exhaust manifold (10). Install intake manifold (5) on cylinder head (2) with sixteen
washers (6) and nuts (7).
4.
Tighten twelve locknuts (12).
5.
Install plug (9) and drain valve (8) on intake manifold (5).
6.
Tighten two screws (18) on starter solenoid bracket (19).
7.
Install air cleaner assembly (WP 0053 00).
8.
Install engine temperature sending unit (WP 0107 00).
9.
Install water outlet manifolds (WP 0080 00).
10.
Install covered manifold heater, if removed (WP 0065 00).
11.
Install uncovered manifold heater, if removed (WP 0066 00).
12.
Install turbocharger (WP 0057 00).
13.
Install oil dipstick tube (WP 0042 00).
14.
Install personnel heater defroster hoses (WP 0251 00).
15.
Install thermostat and housing (WP 0081 00).
16.
Connect battery ground cable (WP 0126 00).
17.
Lower and secure hood (TM 9-2320-361-10).
18.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
0041 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version