CYLINDER HEAD MAINTENANCE - continued - TM-9-2320-361-24-10416

TM 9-2320-361-24-1

0027 00

CYLINDER HEAD MAINTENANCE (Contd)

INSTALLATION (Contd)

WARNING

Ensure engine compartment is free of all tools and working

materials before starting engine. Failure to do this may result

in damage to equipment and injury to personnel.

11.

Start engine (TM 9-2320-361-10). Idle engine until coolant temperature reaches a minimum of

175 F (79 C) before engine shutdown.

NOTE

It is not recommended to hot re-torque this gasket. If any

seepage or leaks occur, a re-torque is required. It must be done

on a cold engine. Re-torque using torque sequence shown,

tighten nuts (12) to 157 lb-ft (204 Nm).

12.

Remove no. 1 through no. 3 injector tubes (WP 0068 00).

13.

Remove rocker arm cover and gasket (WP 0030 00).

14.

Remove rocker arm assembly (WP 0031 00).

15.

Install pushrods and rocker arm assembly, and adjust valve clearance (WP 0031 00).

16.

Install rocker arm cover and gasket (WP 0030 00).

17.

Install injector tubes (WP 0068 00).

18.

Install fuel injector nozzles and holders (WP 0067 00).

19.

Install air intake tube and cap (WP 0051 00).

20.

Connect battery ground cable (WP 0126 00).

21.

Lower and secure hood (TM 902320-361-10).

22.

Release parking brake and remove wheel chocks (TM 9-2320-361-10).

0027 00-6