Table 1. Preventive Maintenance Checks and Services (PMCS) - continued

TM 9-2320-361-24-1

0023 00

PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS) (Contd)

Table 1. Preventive Maintenance Checks and Services (PMCS) (Contd).

ITEM

ITEM TO CHECK/

EQUIPMENT NOT

INTERVAL

PROCEDURE

NO.

SERVICE

READY/AVAILABLE IF:

Annually

Rear

d. Test spring seat bushing by placing

suspension

jack under torque rods (1) and raise

(Contd)

vehicle until springs (3) are raised off

wear pad (7) but not touching spring

bracket (6). Position prybar between

U-bolt saddle (4) and lifting pin (5).

Pull up on prybar. If there is play,

inspect bushings for damage or adjust

as necessary.

NOTE

Use caution not to lose the detent ball

and spring when removing/installing the

pin.

Annually

e. Remove lifting pin (6). Clean and

lubricate with GAA and re-install.

a. Using a .001 in. (0.025 mm) thick

Semiannually Frame and

a. Rivets are

feeler gauge, check for space between

crossmembers

missing or loose.

rivet head and riveted frame member.

Penetration of the feeler gauge

between rivet and riveted member is

reason to suspect the riveted

connection and/or rivet should be

replaced.

0023 00-15