 |
|||
|
|
|||
|
Page Title:
Table 2. STE/ICE-R No-Go Chain Test - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0018 00
SIMPLIFIED TEST EQUIPMENT FOR INTERNAL COMBUSTION ENGINE--
REPROGRAMMABLE STE/ICE-R NO-GO CHAIN TROUBLESHOOTING (Contd)
Table 2. STE/ICE-R No-Go Chain Test (Contd).
NOTE
Test GO 1 (WP 0017 00), VTM Connections and Checkout,
must be performed before running any other STE/ICE-R test.
TK
BATTERY COMPARTMENT--
NG120
MODE
POSITIVE SIDE VOLTAGE DROP CHECKS
NOTE
Check voltage drop across solenoid, and all cables/
TEST NO.
TEST
connections in positive side of starter circuit. Use
procedure outlined below for each voltage drop check.
89
045 VOLTS DC
1
DO TEST PROBE CABLE OFFSET:
Short clip leads of test probe cable W2 together.
Dial 89 into TEST SELECT switches.
Press and hold TEST until CAL message appears
PROMPTING
on display.
MESSAGE
Release TEST.
Wait for offset value to appear on display.
Is offset value within limits of 6.8 to +6.8?
YES
NO
STE/ICE-R is bad. Replace.
2
MEASURE VOLTAGE DROP:
Connect clip leads of W2 across part to be measured.
Press TEST switch.
Press starter switch on vehicle.
The voltage drop across a connection should be less
than 0.1 volt and the drop across a cable should be
less than 0.2 volt.
Repair or replace defective part.
NOTE
After completing repair, rerun GO Chain tests (WP 0017 00)
to verify that problem is fixed and no other problems exist.
0018 00-34
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version