Table 2. STE/ICE-R No-Go Chain Test - continued

TM 9-2320-361-24-1

0018 00

SIMPLIFIED TEST EQUIPMENT FOR INTERNAL COMBUSTION ENGINE--

REPROGRAMMABLE STE/ICE-R NO-GO CHAIN TROUBLESHOOTING (Contd)

Table 2. STE/ICE-R No-Go Chain Test (Contd).

ENGINE CRANK--NO START (Contd)

NG30

MODE

CHECK FUEL SUPPLY:

Verify that there is fuel in tank.

If fuel filters have been changed or fuel tank

has been run dry, bleed air out of fuel system

as necessary. (WP 0064 00).

Drain any water from primary fuel filter.

Continue to drain until fuel appears.

Check for kinked, flattened, or broken fuel

lines from tank to filters and engine. If

equipped with quick disconnect fittings, check

for blockage in fittings.

Check fuel shutoff solenoid and circuitry, and

emergency shutoff.

CAUTION

Before opening fuel line, make sure

area around fuel line is clean.

CAUTION

Operation of engine with red transducer installed

could damage transducer. During this test be

prepared to shut off fuel immediately if engine starts.

Remove transducer before attempting to start engine.

Proceed to step 3.

0018 00-6