 |
|||
|
|
|||
|
Page Title:
Table 2. STE/ICE-R Go Chain Test - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0017 00
SIMPLIFIED TEST EQUIPMENT FOR INTERNAL COMBUSTION ENGINE--REPROGRAMMABLE
(STE/ICE-R) GO CHAIN TROUBLESHOOTING (Contd)
Table 2. STE/ICE-R Go Chain Test (Contd).
TK
VTM CONNECTIONS AND CHECKOUT (Contd)
G01
MODE
YES
NO
Does display light up?
YES
NO
PULL OFF the power switch.
Check W5 connections for reversed polarity.
Check, clean, and oil battery connections and
If only a portion of .8.8.8.8 or four
interconnecting battery cables.
dashes is displayed, a display
PUSH ON the power switch.
module may be burned out. Refer
to TM 9-4910-571-12&P.
Does the VTM display .8.8.8.8 and then change
Repeat step 2.
to four dashes?
YES
NO
No power to VTM, connect
to a known good battery to
see if problem is vehicle
batteries or VTM.
PULL OFF the power switch.
Connect red clip lead of W5 to a known good
battery.
Connect negative terminal of good battery
to ground on vehicle under test.
PUSH ON power switch.
Does VTM display .8.8.8.8 and then change
to four dashes?
Proceed to TM 9-4910-571-12&P
for fault isolation of cable W5.
If cable is bad, replace cable.
YES
NO
If cable is good, STE/ICE-R is bad.
Replace.
Check vehicle electrolyte level.
Clean vehicle battery terminals.
1
Charge vehicle batteries.
Return to step 1.
Proceed to step 3.
3
0017 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version