Table 3. Error Messages

TM 9-2320-361-24-1

0016 00

SIMPLIFIED TEST EQUIPMENT FOR INTERNAL COMBUSTION ENGINE--REPROGRAMMABLE

(STE/ICE-R) TROUBLESHOOTING INTRODUCTION (Contd)

Table 3. Error Messages (Contd).

VTM

INTERPRETATION

READOUT

E024

Test is not valid for VID entered.

E027

Error in entry of compression unbalance constants.

E028

Test just entered cannot be used with control function 06.

E030

VID entered conflicts with speed transducer attached.

E032

Vehicle's cranking speed is varying too much for a compression unbalance measurement.

E033

Error in entry of power test constants.

*Different STE/ICE vehicle connectors have different DCA numbers. You can find out what DCA

connector is connected by entering test 62. These error messages have a special meaning if connected

to DCA number 13 and message is displayed in response to a cylinder (CYL) or UEH (refer to table 2)

entry. In these cases, testing may continue, but the message is a warning that tests using CYL and

UEH information are normally performed with the VTM connected to a different connector in the

vehicle.

0016 00-9