 |
|||
|
|
|||
|
Page Title:
Table 3. Cooling System Troubleshooting Procedures - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0008 00
MECHANICAL SYSTEMS TROUBLESHOOTING - DIRECT SUPPORT (Contd)
Table 4. Clutch System Troubleshooting Procedures (Contd).
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
3. If transmission to transfer case
1. VEHICLE WILL NOT
propeller shaft will not spin,
MOVE OR ENGINE
remove transmission
STALLS WITH CLUTCH
ENGAGED (Contd)
plate and clutch disc for defects.
Verify flywheel condition
4. If pressure plate and clutch disc
are defective, replace (WP 0050 00).
2. Check flywheel condition
5. If flywheel is burned or damaged,
repair and replace flywheel
(WP 0441 00 or WP 0029 00).
2. BURNING ODOR
CAUTION
EVIDENT WITH
Clutch engagement followed by a
CLUTCH ENGAGED
burning odor indicates clutch
improperly engaged and slipping.
When this condition is evident,
inspection of vehicle clutch
operation is required immediately.
Prolonged operation of vehicle
under these conditions may result
in damaged clutch disc, pressure
plate and flywheel.
Clutch slippage due to improper
clutch disc operation may result in
damage to pressure plate, clutch
disc, and flywheel contact at
surface.
NOTE
Light surface discoloration of
pressure plate and flywheel contact
surfaces may be removed with crocus
cloth. Deeper discoloration and hard
spots on flywheel may require
replacement of part.
1. Check clutch assembly condition.
Remove transmission (WP 0131 00).
2. Remove pressure plate and clutch
disc for inspection
1. If flywheel or pressure plate
3. Remove release bearing for
surface is only slightly discolored
inspection (WP 0049 00).
or damaged, clean with crocus
cloth. If damage is greater, replace
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version