 |
|||
|
|
|||
|
Page Title:
POWER PLANT HEATER REMOVAL, REPAIR, AND REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-209-34-2-3
FRAME 10
CAUTION
Use care in putting flame detector switch (1) back
into housing (2). Quartz rod in switch (1) may break
if you are not careful.
1.
Put flame detector switch (1) into housing (2). Screw on and tighten fitting
(3) under flame detector switch (1).
2.
Unscrew and take out terminal screw (4). Put flame detector switch common
electrical lead (5) on common terminal of flame detector switch (1). Screw in
and tighten terminal screw (4).
Do step 2 again for middle terminal screws (6 and 7) and end terminal
3.
screws (8 and 9) on flame detector switch (1).
GO TO FRAME 11
21-60
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version