POWER PLANT HEATER REMOVAL, REPAIR, AND REPLACEMENT - continued

TM 9-2320-209-34-2-3

FRAME 2

NOTE

Match tags on electrical leads with tags on terminals

when connecting electrical leads to terminals.

Put bracket (1) with electrical leads on housing (2). Screw in and tighten

four screws (3), two on each end of bracket (1).

Put two restriction thermostat electrical leads (4) through grommeted

hole (5).

NOTE

Diode (6) must be put back in exactly as it was taken

out. Diode has an arrow on it; the arrow points to

the end of the holder (7) that has the mark.

3. Snap diode (6) into holder (7).

GO TO FRAME 3

21-52