 |
|||
|
|
|||
|
Page Title:
POWER PLANT HEATER REMOVAL, REPAIR, AND REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-209-34-2-3
(7) Fuel standpipe and preheat resistor.
FRAME 1
WARNING
Dry cleaning solvent is flammable. Do not use near an
open flame. Keep a fire extinguisher nearby when sol-
vent is used. Use only in well-ventilated places. Fail-
ure to do this may result in injury to personnel and
damage to equipment.
1.
Clean fuel standpipe (1) with cloth dipped in dry cleaning solvent. Wipe
fuel standpipe dry.
Check continuity through preheat resistor (2) with an ohmmeter. Place
2.
ohmmeter leads on terminals (3 and 4). If circuit is open, get new preheat
resistor (2).
3.
Check compression fitting (5) and union nut (6) for damage.
IF ANY PARTS ARE DAMAGED, GO TO FRAME 2.
END OF TASK
21-48
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version