Section III. POWER TAKEOFF ASSEMBLY

TM 9-2320-209-34-2-3

POWER

TAKEOFF

ASSEMBLY

Section III.

18-13. TRANSMISSION FRONT WINCH POWER TAKEOFF REMOVAL AND

REPLACEMENT.

NOTE

This task is the same for double output power

takeoffs and single output power takeoffs.

This task is shown for the single output

power takeoff.

No special tools required

TOOLS:

Transmission fluid, MIL-L-2105

SUPPLIES:

Case and cover gasket

PERSONNEL:

One

EQUIPMENT CONDITION: Truck parked, engine off, handbrake set.

(1) If working on truck M342A2, remove hydraulic hoist control linkage

assembly. Refer to TM 9-2320-209-20.

(2) If working on truck with front winch, remove front winch control linkage

assembly. Refer to Transmission Power Takeoff Shift Linkage Removal and

Replacement, TM 9-2320-209-20.

(3) Drain transmission fluid. Refer to LO 9-2320-209-12/1.

(4) If working on truck with front winch, remove front winch propeller

shaft. Refer to TM 9-2320-209-20.

(5) If working on truck M342A2, remove hydraulic hoist pump propeller shaft.

Refer to TM 9-2320-209-20.

CAUTION

Keep dirt out of transmission and power takeoff

when doing this task. Dirt can cause damage to

equipment.