 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-209-34-2-3
FRAME 12
If drumshaft (1) is being replaced, the two taper pin holes must be drilled
1.
in the replacement shaft.
2.
Find out the location of the two tapered pin holes in the old shaft by measuring
from the collar location on the drumshaft before it was taken out.
Drill and taper-ream these holes for pins (2 and 3).
3.
Take out pin (4) from the old drumshaft (1) and press in new one.
4.
If either bearing (5) was removed from end of drum (6) press in new
5.
bearing.
Slide collar (7) on drumshaft (1) against pin (4).
6.
Slide collar (8) on drumshaft (1).
7.
Put keyed end of drumshaft (1) through drum (6).
8.
Slide collar (9) on drumshaft (1) and hold in place with pin (3).
9.
10. Slide drum (6) against collar (9) and slide collar (8) against drum (6).
Hold in place with pin (2).
G O TO FRAME 13
18-124
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version