Replacement of Flexible Shaft Assembly - continued

TM 9-2320-209-20-3-4

FRAME 4

NOTE

Some trucks may have speedometer flexible shaft

clamped to floorboards instead of accelerator stop

bolt.

Stand by in cab with 9/16-inch wrench to hold accelerator stop

Soldier A

bolt (1) when soldier B is ready under truck.

Tell soldier A to press down

Put clamp (2) on flexible shaft (3).

Soldier B

on stop bolt (1) with fingers.

Put clamp (2) on bolt and screw on locknut (4) with fingers.

CAUTION

Check that flexible shaft (3) is clear of all moving

linkages and free of sharp bends. Move shaft in clamp

as necessary to feed extra slack through cab floor.

Tell soldier A to hold stop bolt (1) with 9/16-inch wrench.

Using 9/16-inch wrench, tighten locknut (4).

Lower pedal (5) and put connecting link (6) through hole in

Soldier A

pedal. Using pliers, put cotter pin (7) through hole in end of

connecting link and bend open ends of cotter pin.

GO TO FRAME 5

22-28