 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-209-20-3-3
FRAME 2
1.
Hold roller (1) in place, and put roller shaft (2) through holes in bracket (3)
and roller. Put washer (4) on roller shaft.
2.
Using 1 -inch wrenches, hold roller shaft (2) and screw on and tighten
nut (5). Aline a slot in nut with hole in roller shaft.
Put cotter pin (6) through slot in nut (5) and hole in roller shaft (2). Using
3.
pliers, bend open ends of cotter pin.
4.
Using 7/16-inch wrench, screw in and tighten grease fitting (7).
Do steps 1 through 4 again for roller (8).
5.
NOTE
Follow-on Maintenance Action Required:
Lubricate roller assemblies.
Refer to LO 9-2320-209-12/1.
END OF TASK
18-510
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version