 |
|||
|
|
|||
|
Page Title:
STEERING KNUCKLE BOOT REMOVAL AND REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-209-20-3-1
1.
Turn open end of boot (1) right side out, so zipper (2) is now inside.
CAUTION
Be careful not to twist boot (1) when putting it on.
Push open end of boot (1) over groove in steering knuckle (3).
2.
Put clamp (4) over boot (1) so clamp will be in groove in steering knuckle
3.
(3). Using 11/32-inch wrench, hold nut (5). Using screwdriver, tighten
screw (6).
Make sure that clamp (4) fits all the way around.
4.
Lock zipper (2) in place using fine safety wire. Cut off excess wire.
5.
Using cement, seal boot (1) all along cut edge (7) and outside of zipper (2).
6.
GO TO FRAME 3
11-23
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version