TRANSMISS1ON TRANSFER OUTPUT COVER SEAL AND AIR VENT REMOVAL AND REPLACEMENT

TM 9-2320-209-20-3-1

Replacement.

WARNING

Dry cleaning solvent is flammable. Do not use near an

open flame. Keep a fire extinguisher nearby when sol-

vent is used. Use only in well-ventilated places.

Failure to do this may result in injury to personnel and

damage to equipment.

NOTE

Before installing new seal (1), clean mating surface of

flange (2) and cover (3) using solvent.

Put new seal (1) on transfer output cover flange (2) and aline four holes.

Put cover plate (3) over seal (1) and aline four holes.

Screw four bolts (4) with lockwashers (5) through cover plate (3) and

tighten, using 9/16-inch wrench.

Screw air vent valve (6) into cover plate and tighten, using 7/16-inch

wrench.

NOTE

Follow-on Maintenance Action Required.

Replace intermediate and rear tunnel. Refer to Part 3,

para 18-5.

END OF TASK