9-7. TRANSMISS1ON TRANSFER OUTPUT COVER SEAL AND AIR VENT REMOVAL
TOOLS: Cross-tip screwdriver (Phillips type)
Seal, transfer output cover
Solvent, dry cleaning, type II (SD-2) , Fed. Spec P-D-680
Truck parked, engine off, handbrake set.
Remove intermediate and rear tunnel. Refer to
Part 3, para 18-5.
Cover holds down poppet ball for shifter shaft
and will spring up when bolts are loosened. Do
not let spring fall into transmission transfer case.
Using 9/16-inch wrench, unscrew four bolts (1) and take off four locknuts (2).
Lift off cover (3) and take off seal (4). Throw seal away.
Using 7/16-inch wrench, unscrew air vent valve (5) from cover (3).
END OF TASK