 |
|||
|
|
|||
|
Page Title:
TRANSMISSION TRANSFER REVERSE SHIFT LINKAGE ADJUSTMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-209-20-3-1
FRAME 2
NOTE
Soldier A stands under truck and watches reverse shift rod
lever (1) to see if it moves when soldier B shifts transmission.
Soldier A
1.
While watching reverse shift rod lever (1), tell soldier B to shift
transmission into all gears except R (reverse).
Put FRONT TRANSMISSION shift lever (2) in position N (neutral).
Soldier B
2.
Soldier A
3.
If reverse shift rod lever (1) moved, reverse shift rod (3) must
be shortened as follows:
Using 3/4-inch wrench, loosen jamnut (4).
a.
Using 7/16-inch wrench on flat section of reverse shift rod
b.
(3), screw rod into yoke (5).
c. Using 3/4-inch wrench, tighten jamnut (4) against yoke (5).
Put FRONT TRANSMISSION shift lever (2) in position 1 (first
Soldier B
4.
gear).
5.
Do steps 1 through 3 again as needed. Reverse shift rod lever
(1) should be almost ready to move when FRONT TRANSMISSION
gear shift lever (2) goes into neutral (N) position.
GO TO FRAME 3
9-47
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version