 |
|||
|
|
|||
|
Page Title:
TRANSMISSION TRANSFER CONTROLS AND LINKAGE (WITHOUT POWER TAKEOFF) REMOVAL, REPAIR, AND REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-209-20-3-1
FRAME 4
1.
Place rear tunnel (1) over shifting lever (2) and aline tunnel mounting holes
with floor holes.
2.
Set transfer shifting lever (2) to LOW position with 1/4 to 1/2-inch clearance
from floor. This distance is measured at point (A) as shown.
Using ruler, measure distance from top of transfer shifting lever (2) to top of
3.
crossbrace (3) as shown.
4.
Take rear tunnel (1) out of cab.
5.
Using ruler, set transfer shifting lever (2) to same distance from crossbrace
(3) as it was in step 3.
GO TO FRAME 5
9-38
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version