 |
|||
|
|
|||
|
Page Title:
TRANSMISSION TRANSFER CONTROLS AND LINKAGE (WITHOUT POWER TAKEOFF) REMOVAL, REPAIR, AND REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-209-20-3-1
FRAME 2
1.
Slip rubber boot (1) over end of reverse shift rod (2) and slide down to reverse
housing (3). Put rubber boot over end of reverse housing.
2.
While holding reverse shift rod (2) with 7/16-inch wrench, screw on locknut (4)
using 3/4inch wrench.
NOTE
Locknut (4) will be tightened after transmission transfer
reverse shift rod assembly is put back on truck.
3.
Screw yoke (5) onto reverse shift rod (2).
END OF TASK
9-34
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version