 |
|||
|
|
|||
|
Page Title:
TRANSMISSION TRANSFER CONTROLS AND LINKAGE (WITHOUT POWER TAKEOFF) REMOVAL, REPAIR, AND REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-209-20-3-1
e. Assembly of Transmission Transfer Reverse Shift Rod (Transmission Transfers
Without Air Actuated Positive Lockup).
FRAME 1
WARNING
When compressing spring (1) on reverse shift rod (2),
use vise or clamp to hold spring compressed. Be care-
ful spring does not slip out of vise or clamp , causing
injury to personnel.
NOTE
Clean parts with solvent before assembly.
Put one flat washer (3) on reverse shift rod (2).
1.
Soldier A
Put spring (1) on reverse shift rod (2) and compress spring enough
2.
to put on another flat washer (3).
3.
Screw locknut (4) on end of reverse shift rod (2). Hold reverse
shift rod with 3/8inch wrench while tightening locknut, using
3/4-inch wrench.
Put reverse shift rod housing (5) into vise. Put reverse shift rod
4.
(2) into housing.
WARNING
When compressing spring (1) with wood block on reverse
shift rod (2), care must be taken not to let reverse shift
rod slip from wood block, causing injury to personnel.
Put wood block on end of reverse shift rod (2) and slowly press
5.
down reverse shift rod until spring (1) is compressed inside reverse
shift rod housing (5). Tell soldier B when spring is in place.
6.
When spring (1) is in place, using retaining ring pliers, put re-
Soldier B
taining ring (6) into groove inside reverse shift rod housing (5).
7.
Take away wood block and take reverse shift rod housing (5) from
Soldier A
vise.
GO To FRAME 2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version