Replacement of Switch, pn 7760414 with Switch, pn 7064588.
Using diagonal pliers, cut wires (1) close to damaged stoplight switch (2),
Using wire strippers, strip 5/16 inch of insulation off ends of wires (1).
Parts (3 through 6) are in waterproof electrical
repair kit, pn H020-5701060.
Slip two adapter grommets (3) over ends of wires (1) and slide grommets back
on wire. Put wires through waterproof connector shell (4) as shown.
Put two male terminals (pins) (5) over stripped ends of wires (1). Using hand
crimping tool, crimp pins on wires.
Slide adapter grommets (3) down wires (1) and put in holes at back of water-
proof connector shell (4). Pull slack wire out back of shell through adapter
grommets until male pins (5) seat in connector shell.
Push one female sleeve terminal (6) over each male pin (5).
GO TO FRAME 2