Put dimmer switch plunger (1) through hole in floor (2) and
position dimmer switch (3) as shown. Aline two holes in mounting
flange (4) with holes in floor.
Tell soldier A when mounting holes are alined. Screw in two screws
(5) with starwashers (6) but do not tighten screws.
Put protective cover (7) over dimmer switch (3). Slide slotted
side (8) between flange (4) and floor (2) so slots are around
screws (5). Tell soldier B when cover is in position.
Using screwdriver, tighten two screws (5).
Follow-on Maintenance Action Required:
1. Close hood and left side panel. Refer to
2. Replace battery ground cable. Refer to para 7-58.
3. Check operation of headlight dimmer switch. Refer
to TM 9-2320-209-10.
END OF TASK