7-49. OIL PRESSURE TRANSMITTER REMOVAL AND REPLACEMENT.
TOOLS: 3/4-inch open end wrench (2)
Heat resistant sealer, type II, MIL-S-45180
Truck parked, engine off, handbrake set.
Remove air cleaner filter element. Refer to
Make sure ACCESSORY switch is set to OFF
position while doing this procedure. Failure
to do this may cause a short and damage
wiring or transmitter.
Take connector (1) off oil pressure transmitter (2).
Using 3/4-inch wrench, unscrew oil pressure transmitter (2) from adapter
fitting (3). Hold adapter fitting from turning in elbow (4) with 3/4-inch
END OF TASK